[Tinyos-help] what fuse bits for mica2

Philip Levis pal at cs.berkeley.edu
Tue Sep 13 17:35:46 PDT 2005


On Wed, 2005-09-14 at 10:25 +1000, Mark Calder wrote:
> Is this the right fuse bits for a mica2 and jtag debugging?
> 
> AVaRICE version 2.3, Sep 13 2005 16:12:45
> 
> Defaulting JTAG bitrate to 1 MHz. Make sure that the target
> frequency is at least 4 MHz or you will likely encounter failures
> controlling the target.
> 
> JTAG config starting.
> Hardware Version: 0xce
> Software Version: 0x7f
> Reported JTAG device ID: 0x9702
> Configured for device ID: 0x9702 atmega128
> JTAG config complete.
> 
> Reading Fuse Bytes:
>    Extended Fuse byte -> 0xff
>        High Fuse byte -> 0x19
>         Low Fuse byte -> 0xff

I think so, yeah. That's what I use with micaZ, at least. I don't see
why mica2 would be different.

Phil



More information about the Tinyos-help mailing list